Hello again
When I'm doing cycle power on ABB IRC5 I'm loosing all I/O that I've set to "1", is it possible to change some variable (or something) that when I'll do cycle power I'll keep the I/O set to "1"?
Hello again
When I'm doing cycle power on ABB IRC5 I'm loosing all I/O that I've set to "1", is it possible to change some variable (or something) that when I'll do cycle power I'll keep the I/O set to "1"?
Yes. You're looking for "Safety Access Level", and if it doesn't exist, create one that saves value at power down.
Great thanks,
That will do