im trying to find and EDS file for a DSQC 504 controller and cant seem to get it on the ABB site. i think i need robotware 4.0 and only have 6.06 please assist
Robotware 4.0
-
calebjp -
April 3, 2018 at 2:36 PM -
Thread is marked as Resolved.
-
-
This post does not make a lot of sense. The DSQC504 is a connection board.
My best guess is that you are trying to setup DeviceNet on your S4C+ controller. You will need the I/O Plus software option to do this.
ABB Tech Support will usually make BaseWare 4.0 software available for download if you contact them.
Attached is an EDS that may help. -
Good Day Skooter,
I am in the process of doing exactly that (trying to configure DeviceNet on the S4C+ controller) please could you give me a rundown of the process.
I have I/O plus installed and am trying to get a Beckhoff CanOpen EL6751 Master unit to communicate.
Forgive me but I am an absolute beginner so if possible the dummies version would be great.
Thanks
Jamie