Hi all
I have acquired a ZX 165 U with a C32 controller.
It started its life as a sealer In the USA, and then moved to Australia to spray resin on fibreglass tanks.These guys in Oz disconnected most of the I/O and communication cables from the top of the controler and stuffed them into the back of the controller. How do I get hold of electrical diagrames for the C 32 so my electrician can sort out which cables I need and which are obsolete.
The robot, controller and teach are all in good condition with only 3500 hrs on the clock, and will only be used for linear polishing on stone.
Would appreciate any help so I can get this marvel running.
ZX 165 U robot C32 controler
-
Shane Magree -
September 10, 2017 at 12:48 PM -
Thread is marked as Resolved.
-
-
Welcome to the Forum........
Have a look in the Manuals section - specifically: C-Series Documentation & Manuals
You will find a manual called Ext IO Manual, which includes the C3x Series, I think this may assist you in part to locate the relevant connection details.
If not, can you let us know some further details of the connections you have core no for example. -
Thanks for your help Kwakasaki,
Looking forward to lots of detailed reading and problem solving.
No doubt I will have some questions later.
Appreciate your generosity with helping out. -
You're welcome, there are several members who have C3x series experience here, so whatever you come across I'm sure we can assist if needed.
I think the C series/Z series was a very reliable system so would be good for you to get that work horse back into service again.
- Only 3500hrs on the clock as well............many more miles left in that old lady for sure.....