Hi,
At my work we currently purchased an older fanuc arc mate 100i welding robot with an rj3 controller. When we purchased it we tested it and it was working fine and welding. Since we installed it and wired it I have got it almost working but now I get an ARC -046 error every time I try to run a program with weld enable on. The wire+ / wire- also is not working now. The welder is a Lincoln Electric Power Wave 455. I am wondering if anybody has ran into this issue before and if they are able to help me fix the issue. I am pretty new with welding robots but I am able to navigate the controller and write programs. Any help or tips is appreciated. Thanks
ARC - 046 Weld EQ communication error
-
cpiequip -
August 21, 2017 at 11:03 PM -
Thread is marked as Resolved.