HEllo, can i change that : (in picture)
UF1 in UF2 ?
Without passing by the conditions in the program (UFrame = XX and UTool = XX)
HEllo, can i change that : (in picture)
UF1 in UF2 ?
Without passing by the conditions in the program (UFrame = XX and UTool = XX)
What I think you want to do in to change the UT number and UF number used of the taught positions. for instance UF:1 to UF:2 or UT:4 to UT:1
Depend of the software version, you may have an utility called "Tool offset" and " Frame offset".
[MENU]--> UTILITIES--> Frame Offset & Tool Offset
These utilities change the UT/UF number of taught position
I think there is no direct way to do that. You could however use the Direct Entry method and just swap the calculated values (write them down and then input values from UFx to UFy and the other way around).