Hi
I have MPP3H delta robot +FS100 controller. I create project with Motopick. I want to sent project to Controller but i can't.
I put USB falsh on the controller and i change mode from OFFLINE to ONLINE but when i press download project to controller i have error. i use several USB flash too but i have error again.(error is same as picture)
what is problem and what must i do?
Motopick Problem
-
TSGIR -
July 2, 2017 at 1:17 PM -
Thread is marked as Resolved.
-
-
I'm sure you have already figured out the problem but this problem happened to me and it was because i had my computer firewall up. Make sure to turn off all firewall settings when using motopick software. Take Care!