Hello Everyone,
I recently hear that Fanuc offers flow function for handling parts.
Basically I have a part that needs to be places on the rack ( vision is not an option due to budget amount). This rack contains of two poles where part will hang.
I hear that you could use this "flow" function where EOAT will go inside the rack and based on feed back from motors will guide itself in without crashing.
I have over 300 of this racks in our plant , although most of them are the same ( or should be the same) , some are bend .
Can anyone help me please ?
Fanuc Flow function
-
Kuzy2008 -
January 24, 2017 at 2:44 PM -
Thread is marked as Resolved.