Hi,
I have replaced the touch screen of the Fanuc teach pendant A05B-2518-C203#EGN but it didn't work. The touch supplier informed that it needs to perform a calibration. Does anyone know if there is a function on calibrate on the TP and how to perform it? (TP picture attached)
TPU Robot Fanuc A05B-2518-C203#EGN - Touch Screen
-
Luis Santos -
September 23, 2016 at 9:33 PM -
Thread is marked as Resolved.
-
-
what revision software?
that looks like back around 7.7 or so
i do remember some kind of calibration back then, i will continue thinking about it. -
try this, on boot up hold in F1 button. you should get to a microsoft windows (in Japanese) screen. it may be in there.
-
Hi dmbj,
Thank you. I will check.
-
try this, on boot up hold in F1 button. you should get to a microsoft windows (in Japanese) screen. it may be in there.Just making sure, but does this work on R-30iA with not touch screen?
I'm holding F1, cold starting a R-30iA, V7.70, but it does a regular boot sequence.
Don't actually have a problem, just curious.