Hi, All!
I'm having some trouble to configure the ProfiBus MASTER network of FANUC R-30iB (V8.30).
The SLAVE network is working properly.
So, I have only a Festo CPX-FB13 ProfiBus module on the MASTER network. This module is for a manifold, with a 16 bit input card and four valves.
I'm consulted some friends and tried other setups for myself, but the CPX is still accusing bus fault (BF led blinking red), and I can't see the manifold inputs.
The setup I have now follows below. If someone have any hint, I will be happy to hear.
Thanks!