Hi everybody.
DX100 Handling DS3.62.00A(US)-14 with Motosight 2D
Cognex is5605 Firmware 4.09, In-sight Explorer 4.9.0, fixed mount
I have always had a problem where if power to the camera has been cycled I get the Motoman alarm 8113 "Camera Response Time Out" when the robot runs the macro INSPECT in full auto. This alarm will occur for the 1st 5-10 attempts, in auto, before working. Lately, this has been occurring randomly in full auto. It usually goes after 5-10 resets & starts in auto. The camera communicates via Ethernet with the robot, and this is the only Ethernet communication the robot handles.
Does anyone else out there struggle with this alarm? Any solutions / workarounds?
Thanks