Hello. We have welding robot IRB2400L with S4C controller BaseWare 3.2 and welding equipment MIG/TIG (power source Aristorob 500/A314/A324)
In Operating instructions of Aristorob 500/A314/A324 says:
"The robot’s system parameters must first be defined so that the power source and robot can communicate with each other.
This is a question of basic programming which is only carried out during installation.
The programming of the system parameters is explained in full in the welding robot’s programming manual".
Anybody have "welding robot’s programming manual"?
What system parameters need defined so that the power source and robot can communicate with each other?