Hi
What is the simple way to move around tcp??
Any example??
Thanks
Inviato dal mio iPhone utilizzando Tapatalk
Hi
What is the simple way to move around tcp??
Any example??
Thanks
Inviato dal mio iPhone utilizzando Tapatalk
simple way is to select tool coordinate system, correct tool (assuming it was measured correctly), enable drives and jog.
while jogging you may also teach points as you wish, then run program to repeat the whole thing...
Define tool data correctly and then select that tool and use mouse or use XZYABC to move around point.
Most simple and easy way to do.
Thanks panic,
I measure my tool , (only shift x y z whit tool cal entering numerically)but when i jog in tool mode, tcp still in null ..
Inviato dal mio iPhone utilizzando Tapatalk
Thanks nikk same as answer to panic
Inviato dal mio iPhone utilizzando Tapatalk
Use 4 point method and save the tool.
You will be able to find it in tools while moving.
It s not easy measure my tool via 4 point
Inviato dal mio iPhone utilizzando Tapatalk
Try one more thing, enter those data in tool which you have measured and then try to create program using that tool.
what do you mean? in file.dat??
It s not easy measure my tool via 4 point
why?
you can also do numeric entry if you have tool dimensions, relative to flange.
Everything fine..i miss to Save my tool
Inviato dal mio iPhone utilizzando Tapatalk