I have a few S4C+with IRB1400 weld robots and in the system info screen it only monitors 2 fan. Fan 1 running. Fan 2 running slowly. i am wondering if there is a way in parameters or service that can show the status of other fans? or are the other fans monitored at all? When fan malfunction errors apppear it can show errors on 4 to 5 fans at once. Knowing the status of all fans on teach pendant would be nice. Maybe no feedback on some??? Normal or not?
S4C+ cooling fans
-
TillageBots -
July 28, 2015 at 7:41 PM -
Thread is Resolved
-
I have the same problem on one of our s4p+ controllers. it only shows fan 2 and 4? some times after a restart fan 2 runs slow. restart again and all is ok? the status of the other fans? who knows.
-
We remove and check fans yearly, and clean out the housing under the fans. saves down time when the fans fail and burn up the drives
Advertising from our partners
