hi,
We have arcmate120ibe robot with RJ3IBmate controller(2006). We want to add a profibus slave module to controller. We plug the profibus module and then we tried to upload a software to controller.
Last week an integrator came and made a back up from Files section with All Above command. I didin't know about details and i thought that that is a copy of the harddisk. I shared the backup with one of my friends and he sent me a software that belongs to his robot.
We didn't made an image back up at the beginning. We try to upload the software to robot.This screen appeared.
http://i62.tinypic.com/2qk13sz.jpg (Because of the size i put the link.)
And i understood that the version of software that we receive is not the same with the robot's. I asked to the operator of robot, he shared a photo from past about the robot.
http://i57.tinypic.com/o6cvhc.jpg
When we power on the robot the boot monitor appears. The screen below is from the bmon menu. And The orginal software of the robot is V6.30.
http://i58.tinypic.com/2yl6a9x.jpg (Because of the size i put the link.)
After this wrong steps i made an image of the controller. After the image, i tried to upload it and i got this screen.
http://i60.tinypic.com/28mnvj6.jpg (Because of the size i put the link.)
what i need is a image for the robot with profibus slave module A20B-8100-
0440/06B.
Is there any solution that can be done without calling Fanuc?
Best Regards,
Beck.