Hello,
I have 2 smartpads and 2 robots. Yesterday I made a small scratch on one smartpad. The touch screen doesn't work only if I put a drop of water on the scratch. I found a service to repair it but I will have to test the robots in external mode. After I disconnect the smartpad do I need a jumper?
Does someone know a way to "fill" the scratch or I will have to replace the keypad membrane? I think that the warranty it will not apply.
Thank you
Running external mode without smartpad
-
Casius -
June 6, 2015 at 8:37 AM -
Thread is marked as Resolved.
-
-
Hi Casius!!!
On Smartpad you have a white button on top which is the disconnect button. After pressing this button you can disconnect the Smartpad from the controller within 30 secs and the robot will continue to work without any failure. This is the beauty of new KUKA bots. You can use the same Smartpad on other robot for your commissioning.
As for the scratch, I have no such experience so only way is to get it repaired by KUKA expert.
Thanks
-
However, if you disconnect the SmartPad, it will no longer be possible to change modes (EX, AUT, T1, T2) on the robot.
-
Hello,
Thank you for replies.