HI everybody,
We have a DX100 controller that was asked to be delivered with a PCI HMS Anybus Profi-DP card, but instead Motoman delivered it with a HMS SARCR-XFB01 Profibus Slave board. This one communicates with the controller via USB, but
I'm unable to see it in the Management Mode under I/O Modules, only three NONE labes. Besides the board is in Network Offline state showing its #3 LED in red at all times.
Motoman sent an NX100 document to configure it but my guess is that this board is not compatible with the DX100. FYI togheter with with the board are 4 encoders and one S7317-PNDP PLC connected in the bus.
My question is, has anyone made it to use this board-controller combination succesfully?
Many thanks in advance, any help is appreciated!
Regards, FB.