I have Fanuc 2000iB 165F and need to talk to it using Siemens profibus. I have not worked with siemens profibus. I am AB guy through and through but when customer specs than have to fellow.
So can anyone help please?
Fanuc Profibus
-
parends -
March 24, 2015 at 3:51 PM -
Thread is marked as Resolved.
-
-
Configure it as rack 67 slot 1 start 1 for both inputs and outputs.
If you want I can send you a config off of one of mine so you can load it and look at it. -
yes if you would send me please
-
Profibus is to Siemens what DeviceNet is to Rockwell.
-
Hi!
Do you have some manual for configuration profibus via robot?
Which card you have on board your robot controller?(master or slave)Did you upload gsd file of your profibus card into your project for Siemens?
Regards,
Scotty