I have to add an external base axis track to a new DX-100. I will have the kit installed soon. I had to add an internal wire harness and amplifier in the controller.
My questions are, how do I set up the system to recognize the new base axis? I’m also thinking I should have to adjust a pot or two in the controller.
Any guidance will be helpful.
external axis track
-
popbot -
December 18, 2014 at 2:38 PM -
Thread is marked as Resolved.
-
-
Hi , section 11 of the Standard DX100 "Instructions manual" , this manual is supplied , on disc. As well as printed paper in most countries.
Not to be confused with the Arm Model "Instructions manual".
If you haven't got it , Send me a PM with your email address and I'll fwd it to you or go to the Motoman Web site, "Support > Documentation" And download it . -
DX100
INSTRUCTIONS
FOR NORTH AMERICAN (ANSI/RIA) STANDARD Part# 155494-1CDSection 11 is for Manual Brake Release Function. I must not have the correct manual?
-
Hi , These are the manufacturers manual numbers ,
DX100 Instructions .
CTO - A215 : Asia section 11.2
CTO - A216.1. : Euro. Section 11.2
CTO - A217.1 : USA Section 12.2
If your still having grief PM me.