Oh ok, very good to know! No problem, I just sent the files to the correct address.
Installed Handling tool on rj3 controller now I have errors
-
Harleydude -
December 4, 2014 at 6:32 PM -
Thread is marked as Resolved.
-
-
Looking at the backup I don't see the control reliable option at all. This could mean that it is not even available for the LR mate for RJ3. I don't have an RJ3 mate controller manual so I can't look at the specifics for the LR mate's safety wiring.
-
But when I was in the controlled start menu it was in the list and I was able to "start" installing it. After that it asked for the A2 disk.
Hmmm.. The controller has the Auto/T1/T2 key so what should I do now to get the alarm off? Which robots do you think my i-cabinet R-J3 controller could have been used with before?
-
LR mates do not share cabinets with any other robots.
They are unique and so is the software.
I think you are going to have to contact Fanuc and have the software reburned.
Do the F numbers on the cabinet and the robot match? -
Okay. That was also a good point to check the number, they do match. Don't know how the S430 programs got there I think we will try to manage with the alarm, after all it's only irritating. But anyway thank you very much for your help!
-