Could some please point me into the right direction or let me know where I have gone wrong.
I have been attempting to Initialization Dual Servo Gun.
CTRL START
MAINTENANCE following are listed
R-2000IB/210 (A05B-2440-4601)
SERVO GUN AXES (A05B-2440-4869)
SERVO GUN AXES (A05B-2440-4869)
It will allow me to add the gun but when i press exit on the Total servo Gun Axes screen it give me a message
'Even number of axes needed for dual gun.'
EQ1 equip_type was changed to air gun
I added the first one to Group 2 with the configuration of
FSSB Line 1 (Main Axis Card)
Hardware start axis setting = 7
AMP Number =2
Group 3
FSSB Line 1 (Main Axis Card)
Hardware start axis setting = 8
AMP Number =3
Spot config
number of equipment 1
number of weld controllers 2
current equipment , gun 1,1 " I try 2,2 or 1,2 and 2,1 still didnt make any difference on the SETUP SERVO GUN SCREEN in CTRL START
On SETUP SERVO GUN SCREEN in CTRL START
Equp Number = 1
Equip Type = I chosen Servo GUN
it tell me there is multiple nobot group avialable when I click OK
it ask me to assign Equipment 1 to nobot Group 2?
If I press to Equipment 1 to nobot
If I press no it prompt me assign Equipment 1 to nobot Group 3
If I hit yes on any of those group
with a message on the bottom that Dual Gun Requires even number of axes
The setup screen revert back to AIR