Hello Forum,
can someone please comment on an unusual behaviour I am getting from a KR3-KRC3?
- The robot is mastered, there are no alarms or errors and the system is in full production with no problems whatsoever.
- end of shift, the controller is turned off, again with no errors or warnings. Windows is shutting down normally, the batteries, the charger and the power supply are all normal.
- During power down, no one is moving the robot, or disconnecting cables, or even touching anything.
- next morning, the robot asks for mastering on all axis.
I have reinstalled the KSS (but not windows). What do you think, please? Probably, hardware malfunction?
winXP with KSS 5.12