I'm new in robot milling and i need help loading SRC file created in IRB CAM in KRC1 control.
Need help loading IRB Cam SRC file in KRC1
-
jofre7777 -
June 23, 2014 at 4:09 PM -
Thread is marked as Resolved.
-
-
what KSS version?
-
Where can I find this?
-
I was just experiencing the same problems as you. The way i did it was to
Share the KR C1's hard drive on the local network and then
putting my .src file in the "\C:\programme\krc\poweron\R1" folder.
(when i do it this way i have to preform a cold-boot for it to show up in the R1 directory in the KUKA interface.)another way of doing it without preforming a cold-boot ( which takes several minutes), is to load your file to the KUKA hard drive or floppy station, then you browse the "Drive" option in the "file" menu, in the kuka interface.
There you:
locate your file
select "edit"
copy the whole content
"file" -> "robot" -> "all file types"
select "new"
paste the content of your file into the new file you just created.
close, save, select, and run.
(some actions require "expert mode")The reason i do all the copying and pasting is because i can't get the KR C1 to load files directly from the hard drive.
If someone knows a faster better way to do this please share your wisdom. -
Where can I find this?Something like this: open attachment
-
what's the newest version could C1 controller updated to?
thanks.
Something like this: open attachment