Hi everyone!
i am new abb user. I bought ABB IRB 2400 m96
s3
when i push death switch then i have error "contactor active error" and can not run it. What can i do for it?
contactor active error!
-
RoboterTurkey -
June 23, 2014 at 1:22 PM -
Thread is marked as Resolved.
-
-
Change Contactor and finish
-
Hi,
The KM1 and KM2 (Motors On Contactors) only can be activated after the KM3 (Supervision Contactor) are activated.
So when you push the enabling device (deadman switch) you must see the KM3 activation and after the KM1 and KM2 activation.ABB recomends the following steps:
37001: Contactor activation Error
Motor ON contactor did not activate or Motor ON signal is not distributed through auxiliary
contact.1. Restart system
2. Replace Motor On contactor or auxiliary contact
3. Replace system boardI hope I have helped you.
Best regards.
-
Do you have electrical diagram?