Thanks all! the problem is solved. I changed dse board and it's work.
Posts by RoboterTurkey
-
-
So, How to convert? (kss 5.5 to kss 8.3)
-
Is it possible to convert programs already made on KR C2 to KR C4?
-
Do you get any message on the smartpad?
-
Hi everyone!
I need s4 2400-m96 boot disc2. Can anybody help me? -
I cleaned mfs card and the fault gone. but i have new faults. i attached images. RDW card, sockets, cable, wires are ok. i cant changed the machine data. anybody help me?
-
Do you have electrical diagram?
-
Hey Markopo!
Did you solve the problem? I have same problem -
Thanks Marek.
the problem was motor cable. now it is ok. thank you -
KRC1 kr125
the robot can not open. Failure is this! I dont know what is this? if your any idea... -
hi everyone!
VKRC1 kr150
I have "BRAKE ERROR PM1" failure. Do you have any idea about this?
-
Hi everyone!
i am new abb user. I bought ABB IRB 2400 m96
s3
when i push death switch then i have error "contactor active error" and can not run it. What can i do for it? -
-
Hi everyone!
I have KRCDIAG and i want to read logs but i cant open crosslog.cl3 and eventlogs files.
KRC4 8.2.25 -
Try to write the device name with capital letters
LG-D802 cihazımdan Tapatalk kullanılarak gönderildi
-
I dont want move E1 separately from A1-A6. All they have to move synchronously. When E1 value is diffrent from '0' , whichever value i set it doesnt matter , it makes slow the robot. So i have to make all E1 of linear points '0'
LG-D802 cihazımdan Tapatalk kullanılarak gönderildi
-
If i dont set "0" then robot moves slowly. I dont know why but exactly like this. I had a cycle time problem, i tried something and found this way(set "0" value) robot accelerated! So, we are using kuka's commands (hemming start, hemming stop, roller on, roller off, hemming init) i mean i dont set $async_axis, everything is in library_hoq. Would you mind if i ask your e-mail? So i can send backup.
LG-D802 cihazımdan Tapatalk kullanılarak gönderildi
-
I set "0" value for e1. Because how fast the robot moves, e1 set its own roll speed to keep up with the robot's speed according to roller's diameter.
-
Krc4 kss8.2 kr210 2700 prime rsi1.1.0
Kuka-hoq-hemming v2.0.1
Hi all
My problem is this! This error occurs while processing. What can be the reason?LG-D802 cihazımdan Tapatalk kullanılarak gönderildi
-
VAR clock clock2;
VAR num time;
ClkReset clock2;
ClkStart clock2;
WaitUntil di1 = 1;
ClkStop clock2;
time:=ClkRead(clock2);
if clkread()>5 then
set do_1;
endif
Is it correct?LG-D802 cihazımdan Tapatalk kullanılarak gönderildi