Hello,
Starting Fanuc with R-H controller.
Battery was drained, since not changed after year 2K
We try to restore from floppy:
Disk1 - Configuration Software Disc V2.23P
Disk2 - Standard System Software Disc No.1 V2.23P
Disk3 - Standard System Software Disc No.2 V2.23P
Disk4 - System Utility Disc V2.23P
Disk5 - Servo Parameter Setting Program Disc V2.23P
Instructions how to install that
1) Copy all the diskset to 3,5" DD floppydisks and label them.
2) Boot up, hold User PB1 and User PB2 until BMON> is showed.
3) Type 'Device' and press 'ENTER'.
4) Type 'Init CM0'.
Here system halts with message:
No such device configured on this controller
So where it is