Hello,
How to setup Roboguide in a way that a connected HMI(Monitouch) can change registers and IO?
Used controller: Ri30A
Goal: Testing a real HMI connected to computer running Roboguide
The real world robot and HMI-panel configuration is working.
The connection I'm using is ethernet, used protocol on HMI is 90 Series SRTP communication.
As Roboguide is simulating the webserver fine, I asume the SRTP communication should work, but for SNPX/SRTP port 18245 is not open (firewall also disabled).
Please, tell me if this is possible.
Thanks in advance,
Onno