Hello everyone.
I just want to know How can I connect to Ethernet/IP in a FS100 controller because it comes with EthernNet 10 Base T/ 100 Base TX.
Thanks.
Hello everyone.
I just want to know How can I connect to Ethernet/IP in a FS100 controller because it comes with EthernNet 10 Base T/ 100 Base TX.
Thanks.
Do you have a Ethernet I/P board installed? When Yaskawa installs the board they set it up. There is a manual that comes with the board also.
95devils:
I don´t know because the robot isn´t ours it´s going to be borrowed by other factory, so I don´t know if thecrontroller has it.
That is the only way to connect to EtherNet/IP? Installing a special board
To accomplish Ethernet/IP, you need the Ethernet/IP hardware installed.
Plain and simple!