Hello everyone,
Do anyone here have ever used 210WE (water environment) robot for high pressure washers? I'd like to share experience with and get some advice from you.
We applied several 210WE robots without protective boots in washer chambers. And we used approved detergent (SP735) under 55℃ condition, no high pressure spray direct impact on the robot surface, blah-blah. Though we think we did everything according to FANUC requirements, we still suffer peel of yellow paint on the robot arms.But luckily, so far no further damage of O-ring/seal/reducer occurred.
Of course we feedback to FANUC and they suggest the temperature maybe actually out of control inside the chamber. I don't buy this presumption quite well but we have no experience before or proof at hand.
Do anyone know why peel of paint ? And does peel of paint really deteriorate to mechanical damage?