Does anyone have any experience with hooking up Motoman ES200N with NX100 controller to HAAS Lathe via Devicenet ? I have never done hookup through the network. I have some experience hooking up robots by hard wiring them. Is there any literature or someone willing to shed some light on the topic ?
HAAS Lathe Hookup
-
samexman -
March 20, 2014 at 7:14 PM -
Thread is marked as Resolved.
-
-
Haas makes a "robot ready interface". From my experience, Haas was not good in supporting it. Calling their tech support was pointless as no one had any understanding of what exactly the interface did.
I eventually did track down a diagram from them that helped. I might be able to dig it up.
-
I would appreciate any help you can give me.
-
Hopefully this helps get you started.
This was for the DeviceNet interface.You will have to setup the Robot as master with your CNC as slave node.
-
Thank you very much for the information.