He guys
First i wanna say sorry for my Bad english....
So i have a Problem it calls SYST-013 ENBL Signal from UOP is lost
I don't have an User Manual so i hope some One can help me to reset this
He guys
First i wanna say sorry for my Bad english....
So i have a Problem it calls SYST-013 ENBL Signal from UOP is lost
I don't have an User Manual so i hope some One can help me to reset this
hi Falling Fog
Welcome to the robot forum
Are you sure is -013 and not -032 ?
Do you have a PLC connected to the robot ?
If you are using UOPs check to see if the Enable input is on.
the Problem is that i can say in my program for my teach postion touchup. in the Pendant i See Position its been recorded. okay than i Start this Programm new and look this postion what i teach in the First step isn't recorded and the robot Drive to the old postion. and on the Pendant stand this .....Syst 013 enbl Input from UOP is lost
Hello again,
Ok i have looking and i'm sorry what i say.
The Problem is what "Fabian Mundoz " say , it is SYST 032 enbl Input in UOP is lost.
Please give me an answer !