Hello
A have a problem i have done a IF panel
On one robot then a did a copi off the Ifpanel.dat file
Now i have tried to load it to another
Nx100 system that all ready have a
If panel but it is blank.
My panel wont come up.
I have tryed to switch the FD parameter
That switches if panel functon On and off.
Still wont work.
What am i doing wrong?.
IF panel problem NX100
-
jocke75 -
October 26, 2013 at 7:38 PM -
Thread is marked as Resolved.
-
-
you must have activate the if panel function. and simply recreate it.
-
I have the funktion activated.
So a have to write the if panel on the new controller all over again?. -
They might sound ridiculous
Save the .dat from the bad robot
Load on your computer screen both .dat
Copy and paste the info necessary from one two another. Try just a couple of "squares"
Save it and put it back in the robot
See what the result is -
How do i load it on my computer?.
-
You've done copies from one robot to another, I'm assuming you have the card
Go to a electronics/computer store and buy a USB card reader, then hook it up to your computer OR
if you have and old laptop, they used to come with the card readerThen use Wordpad or similar to look at the file. Windows will ask you for the first time how do you want to read this *.dat file, select Open with ...