Hello every one.
I have a 360 safe robot.
There are some fault as
404 emergency stop safety controllr
436 short circut braking request by RDC 1
How i can solve this problem.
I connected x40 and x211c according another robot,that is working,exactly.
Hello every one.
I have a 360 safe robot.
There are some fault as
404 emergency stop safety controllr
436 short circut braking request by RDC 1
How i can solve this problem.
I connected x40 and x211c according another robot,that is working,exactly.
Hi
I am installing a krc15-2 secend hand robot.
I have this message Drive_stop_not_req.
I want to connect beckhoff kl5200 devicnet for may i/o also i enable devicnet in iosys
But untill my module is not connected.
Hi,is is possible please send me your robot picture.i have one machine data with this type of robot and i dont know witch robot is for this controller.thanks.
witch menu is safe configuration? or witch tab?
can you please send me where is safe configuration.?(directory)
sorry, i sent worrng picture.
Hi, i replace the new machine data(expert mode) and open it then close it(save is not possible because did not any change) and reboot but again i have last faults.
please help me and explain more.
thank you
robot name plate
hi krc version
Hi every one.
i installed a KR360 L240-2 safe robot.
the name plate \MADA\ is KRC2\KR360_2\L240\FLOOR and $Trafoname is KR360L240@ H C2 FLR ZH360 and machine data name in hard disk is KR360L240 H C2 FLR ZH360.
so my robot movement x , y ,z in global mode is not go straight in one direction and twisting another axis.
i copy from another file this file "mada\KR360_2\L240\Floor\R1" and replace with my old file. the axis movement in global mode in x,y,z direction amended but after restart of robot the below fault is coming
1- invalid configuration on SafeRDW
2- EMERGENCY STOP safety controller
3- short circuit braking request by RDC1
if is possible help me.
Regards.
Hi every one.
i installed a KR360 L240-2 safe robot.
the name plate \MADA\ is KRC2\KR360_2\L240\FLOOR and $Trafoname is KR360L240@ H C2 FLR ZH360 and machine data name in hard disk is KR360L240 H C2 FLR ZH360.
so my robot movement x , y ,z in global mode is not go straight in one direction and twisting another axis.
i copy from another file this file "mada\KR360_2\L240\Floor\R1" and replace with my old file. the axis movement in global mode in x,y,z direction amended but after restart of robot the below fault is coming
1- invalid configuration on SafeRDW
2- EMERGENCY STOP safety controller
3- short circuit braking request by RDC1
if is possible help me.
Regards.
thank you very much for your quick replay.
Your mean is This message is simply information and that is not reason to ebunded my robot start in ext mode?
When i select ext mode and push start S and I color change to green but R is disable and gray.
Hello firends.
I have this problem too.
Sefatye mode not possible, how i can remove this message?