Posts by CharlesWar

I think that the problem come from the Switch, the network goes through different switches and some of them are managed I need to verify with IT

Thanks

Thanks for your help, I have already the backup of the Robot, and put the new IP, in the WAN port, so in this moment I can connect to the robot from WAN port and RS can see the robot. the problem now is from the switch to the PC.

If I connect the Cable in the switch to my Laptop I can see the Robot with RS, But If I try it from my desk I can't see the robot and I can't make ping

Hello

I have been making modifications to some ABB Robots but now I want to add these to the company network, The company has a corporate and process network, but I don't know how to do it, the process network uses an IP 11.16.32.XXX, I have not found an example to modify the IP and add the controller, I am a bit lost and I don't know where to start.

The controller is IRC 5, ABB

I Find this

FN801 - DIM

FN645 - MOVEX

FN310 - INH

FN822 - GETPOS

FN826 - OPEPOS

FN638 - ADD REAL VARIABLE

FN809 - POS2POSE

You can review the manual in the Teach of the robot

I will try modify with it next week.

regards