panic mode SkyeFire thank you very much for your answers!
Posts by om1
-
-
panic mode thank you for your attention to my message... I have KRC4 compact. The command "ANOUT" can be used to apply voltage to the analog output.
Q: where are these analog outputs located?
-
Hello everyone! Looked through the entire forum, not found information on this issue. There is a KRC4 compact. It is necessary to apply a signal (voltage) to the device that performs certain actions (in fact, to activate these actions, you need to press a button or pedal, after which the sequence of actions will begin). Device without controller, therefore digital data exchange is excluded. Could not find information where exactly is the analog output. I understand that i can buy a module for EK1100 for analog outputs, but i want to understand whether it is possible to do without additional purchases?