Hello, how do i set up a torch reamer if the robot I'm using isn't connected to a PLC? the reamer isn't connected to the robot controller yet.
So i will need help to hook that up in the controller. I'm new to robotics so have patience with me lol.
Posts by mttmiracle21
-
-
Hello, is there any way of direct entering to change a postion? like if i wanted to change the value of the z from 1800mm to 1600mm.
-
I am Putting in a XRC 2001 robot. im new to motoman i cant get servo when i power up the controller. where is the circuit or fuses that I can check? I can jump it out and it jogs just fine but as soon as i try it without jumping out it dont work. it dont alarm out it just will not get servo i can here something clicking inside the controller. Any help would be great Thanks!!!!!!!!!!!
-
Hello, I'm running fanuc vision 500 ia/3DL. its not communicating with the robot could this be a software problem? if so how can i fix it while in production.
thanks very much for any info that i can get. -
I'm new to fanuc I need to shift my program -300 mm
But not sure how to go about it. It's a rj3 controller. I need to either direct entry or do a whole program shift but I need help doing this. Any help would be appreciated. -
hello, I'm new to roboguide. how do i put a program from a usb stick into the roboguide. i thought it might work the same as it does on the real pendant but it doesn't. thanks