I can execute the karel program but i can,t see structure of program .
How can see karel program in teach pendant ?
Posts by ELECOMP
-
-
hi
I wrote the karel program in olpc software and compile to the .pc file and load to controller with USB port on teach pendant . now i want to open this file and executed that .
thanks -
Thanks scotty
I found the .pc program but I can,t open .pc program and run it . when i select the program , Invalid program selection error appear top of the teach pendant . and in Detail section I can,t change any things .
please help me step by step -
Hi
I have LRMate 200ic robot with R30ia controller I wrote karel program in olpc software then convert to .pc file and loaded in controller . How can i open this file and executed that ?
thanks -
thanks eureka for replay
I want to connect to intrlink that I use RobView but Intrlink Doesn't running .
can You help me ?
It works with ethernet port but i want use RS232 ( com2 ) port . -
Hi
I want to connect to IntrLink with RS232 for S4C+ . How can i do this work ?
Wiring of cable as the attach file. -
Hi megatooL
I tested for compactIF . But it's wrong .
thanks -
Hi
I want to add the RAP Communication option for S4C & S4C+ without define new system with Robinstall .
Is it possible ? if Ok How can i do ? -
thanks for replays
I tested both command and just IF Doutput(do1)=1 command was true . -
hi
Is it possible use do in if instruction as blow :
IF do1=1 THEN
WaitTime 1.5;
endif
if it is possible How can i use ?
thanks -
Hi
I want to changed the tooldata without any change the position in program . does any command for this ?
my controller is S4C+ with IRB140 .
Thanks -
Hi
I need manual for js-05 robot with a87 controller .
-
Hi everyone
I have IRB140 with S4C+ controller and the robot work correctly but sometimes error blow appear .
%0.3V is out of tolerance
Check:
Check Power supplies.
Where is the problem ?
Thanks -
Hi sandeep.lerio
I sure floppy drive and floppy disk as well but i don,t sure the system image file .
I use the backinfo files in backup folder for RobInstall .
can you send me a correct key ?
thanks -
Hi everybody
my problem solved . it was in wiring transformer unit . in XP30 terminal Unclench wire number 123 .
thanks for all replay -
Hi
I have IRB140 with S4C+ controller and i want to define new system . i make the boot disk with RobInstall and the cold start the controller and put the disk1 in the floppy drive when i press the key boot disk the error wrong disk-1 appear . where is the problem ?
thanks -
hi
I changed all of the board in the controller with another controller but the problem haven,t solve .
in the log file I have Fan malfunction error (20306) in the end line after A few moments . whats this error ?
is it Related with my problem ? -
thanks everybody for helping
the problem was in CN1 connector on the servo amp . there is one small Conductive object between CN1 base . I Bring out this object & Problem solved . -
Thanks for your help .
Its very useful for me . -
Hi
I need boot disks for the s4 controllers with IRB2400 including ADVANCED FUNCTIONS and RAP communication. for communication between PC and S4 controller .
Thanks