In advanced tab, select "FANUC Ltd" base parameters
I was on the same trouble and this was the solution. Thank you
In advanced tab, select "FANUC Ltd" base parameters
I was on the same trouble and this was the solution. Thank you
Yes, I have it aswell.
Jose Eduardo Tlalpan have you tried reinstalling RG and selecting FRVRC V8.20 (or any other versions related to V8.2)?
I tried it also, I just have the 8.20 and 8.30 versions
Have you tried running it through WinOLPC instead of HandlingTool?
Yep, I tried this without succes.
Yes, I have it aswell.
Jose Eduardo Tlalpan have you tried reinstalling RG and selecting FRVRC V8.20 (or any other versions related to V8.2)?
Yes, I tried this but in the options I looked FRVRC V8.20, and FRVRC V8.30. I created a robot with 8.20 version with no results. Thank you for your support
I have versions of software that are built specifically for a certain customer, that isn't a FRVC supported version. However, I can edit the version and Build ID in the backdate.dt file to 'trick' RG into thinking it is a supported version. Not sure about V8.23, but you can give it a try. For example, I would edit V8.23/xx to V8.20/xx:
Your backdate.dt file:
Code Display More20/11/23 01:57:44 Version: V8.23P/06/None Build ID: V8.23 4/10/2020 1A05B-2500-H551 1A05B-2500-H521 1A05B-2500-J684 1A05B-2500-J765 1A05B-2500-R663 1A05B-2500-J567 1A05B-2500-R784 1A05B-2500-R650 1A05B-2500-R694 1A05B-2500-R809 1A05B-2500-R850 1A05B-2500-J541 1A05B-2500-J878 1A05B-2500-R843 1A05B-2500-J873 1A05B-2500-R848 1A05B-2500-J945 1A05B-2500-J946 1A05B-2500-H746 Z
Edit to:
Code Display More20/11/23 01:57:44 Version: V8.20P/06/None Build ID: V8.20 4/10/2020 1A05B-2500-H551 1A05B-2500-H521 1A05B-2500-J684 1A05B-2500-J765 1A05B-2500-R663 1A05B-2500-J567 1A05B-2500-R784 1A05B-2500-R650 1A05B-2500-R694 1A05B-2500-R809 1A05B-2500-R850 1A05B-2500-J541 1A05B-2500-J878 1A05B-2500-R843 1A05B-2500-J873 1A05B-2500-R848 1A05B-2500-J945 1A05B-2500-J946 1A05B-2500-H746 Z
I try this, however the same advertisement appears on RG "The file backup requires version v8.23 wich is not installed. Run de FRVRC setup then try the operation again."
Hi to everyone, I am trying to install the 8.23 version controller cause I need to run some backups on roboguide. The problem is I cant get the FRVC to add.
Do anyone know how to get the version controller?