that is just telling that MOVE ENABLE is low. check PLC side logic and if you are not using EXT mode, set this signal to 1025 (always true)
Already check and change to 1025 still same error KSS15073
that is just telling that MOVE ENABLE is low. check PLC side logic and if you are not using EXT mode, set this signal to 1025 (always true)
Already check and change to 1025 still same error KSS15073
Now all errors settle and now only error exist is KSS15073 about safety node error and not settle even change all servo drives ccu board.
Again error KSS00203
Now all errors settle and now only error exist is KSS15073 about safety node error and not settle even change all servo drives ccu board.
hi good day everyone
My robot got error KSS00203 since 3 days first day error come change KPP and KSP its okay and run nice for 1 day and then again error same and I try check all inputs all wires drive even change ccu board still error is there can anyone guide me what is issue and solution