Hello everyone!
New to the forum & thankful for all the posts I've run across here thus far. I have a welding robot with a MIG gun and trying to hardface steel parts with Stellite 6 (.045"). I wanted to see if anyone had any suggestions for weld settings (Volts, Wire Speed, and Robot Speed) to get a baseline. Currently I'm running my settings at 18volts 220WFM and 20inch/min and getting terrible results. Anytime I increase these values, I seem to get burn back almost immediately. I'm about 1/2" stick out length from the material.
Would appreciate any suggestions or thoughts - Thanks in advance!