Because it is being used in a GSTR-GOUT. Search for address 3050. You will need to break the group out.
Yasnac MRC ALARM 310
-
gkostecki -
June 21, 2023 at 5:36 PM -
Thread is Unresolved
-
-
Because it is being used in a GSTR-GOUT. Search for address 3050. You will need to break the group out.
Thank you!
Now I know one thing more.
I am also looking for a solution to the problem of powering the drives, I have the same problem as discussed in this thread, maybe you know a solution?
ThreadMRC: Servo On trouble
Hi,
i have some problems with an old MRC robot (European model). It wasn't used for more than 6 years and now it give me some headache. I don't have much experience with this the old motomans and only have some basic knowledge of the NX and DX machines.
The robot did't start, so I made a reset on the MCP01 board. (there was no other option.. it started directly on the maint. mode) I think that wasn't clever, because all settings are deleted?
I made a full backup at that point, but it seems that…Phill_76December 11, 2012 at 8:43 PM -
North American, European, or Asia standard controller?
Do you have a deadman switch?
-
European standard. Pressing deadman switch lights up the LEDs on the MEU01
-