I’m new to the forum and new to robotics. I just purchased a used MA1440 with DX200 controller and RL350 welder. The welder shows 200/220v at 50/60hz and 380/400V at 50/60hz. What is the most common way to power these welders in the US? I have 480v at 60hz available or with some work I can get 208v at 60hz. It seems odd that I would have to use some sort of step down to use the higher power rating. Thoughts?
Motoweld RL350 Questions
-
Galgo -
June 3, 2022 at 2:10 PM -
Thread is Unresolved
-
-
-
220v
thank you