Hi there,
I am about to upgrade the application with the Robot mentioned above.
I would like to use built in solonoids with air ports near the EE connector. Here are my questions:
1. Are those solonoids available in each robot, or is it optional?
2. Does it have another Air supply for those solonoids?
3. Do I have to configure anything after installation of the gripper or can I just operate it via RO?
PS: I undo the connetor lock and tried to operate RO's but air pressure did not appear on any of the ports. On robot base I realised that one 10mm pipe is covered and the air pressure is not plugged into it.,