Hello,
does enyone have a sample program with seam tracking and searching commands?
Thanks,
Bogdan
Hello,
does enyone have a sample program with seam tracking and searching commands?
Thanks,
Bogdan
I could give you an example from an S3 controller with weldguide and smartac, but I'm guessing that's not what you're looking for so please elaborate on which controller / software and which tracker....
Hi, an S4 od IRC5 would be ok. the rest is not that important.
Thanks,
Bogdan
PROC rutinxy()
WGS_Setup tw_ref,cs_bias,tw_gain,cs_gain\TR_Mode:=1;
ArcL\On,pxpla_4,v300,sm1,wd1,wv1,fine,TPKI_15BE;
ArcL\Off,pxpla_5,v8,sm1,wd1,wv1,fine,TPKI_15BE;
ENDPROC