We are looking at a Fanuc M710 for our small tool shop. The dealer says we will need 3 phase 480 with a minimum 15 amp circuit. Our service is 240 volt 3 phase. Any advice on a step up transformer size, wiring, and breaker size would really be appreciated. Thanks for any help.
Fanuc M710 Electrical Requirements
-
Bob49 -
November 17, 2019 at 8:15 PM -
Thread is Unresolved
-
-
Just buy step-up transformer for 30-60 amp and do wiring based on standards of your facility and country.
Usually you takes 230Amp from you main power enclosure from separate circuit breaker(CB), run this wires to yout step-up transformer, from transformer run to additional disconnect box with fuses, from there go to your robot.
I did same thing in our previous facility. I have old step-up transformer so it doesn't make sens to share obsolete part number. Just make sure that your wont hurt feelings of your local electrician and you won't have problem with inspection.
-
Thank you Scotty for the information.