Long story short, I have Fanuc R-J3iB controller and M-16iB/20 robot. I'm trying to connect controller to my PC via Ethernet cable through the "Host comm" -> "TCP/IP" menu.
The problem is that i can't configure ip address and other stuff from here. I saw in every single manual that there must be something like that:
____________________________________________
Robot name:
Robot IP addr:
Subnet Mask:
Board address:
Router IP addr:
Host Name (LOCAL) Internet Address
1 ********** ******************
...
Host Name (SHARED) Internet Address
1 ********** ******************
...
____________________________________________
but I only have something like that:
____________________________________________
Node name:
Router name:
Board address:
Subnet Mask:
Host Name (LOCAL) Internet Address
1 ********** ******************
...
Host Name (SHARED) Internet Address
1 ********** ******************
...
____________________________________________
So, may be there is a problem in my old Teach Pendant 7D01/091 or in software version? Is there is possible to update software? If this is not possible, is it possible to somehow implement the robot's program's file exchange between the controller and the PC?
Respectfully, Twisted Sandwich.