hi there.
this error has started to come up on a fanuc robot that iv been called to look at. i have never seen this message before has anyone ever come across this or know what might fix it. i have never come across this message before
controller start up time out
-
luke12 -
June 14, 2019 at 2:03 PM -
Thread is marked as Resolved.
-
-
I've ran into the same situation with mig robots that use fronius as a welding power supply. I just have to make sure that my welders are on prior to turning on power to my controllers. Maybe it has something to do with communication across the system...
Not sure what your process does so my situation may not even relate to yours.