Our IT department decided it was time to update to new laptops. We had 2 laptops that were on Windows 7 Enterprise but the new one's are on Windows 10 Pro. We use for these on 5 different robots for palletizing finished cases. We loaded the Roboguide software to both and did the license transfers. We were then able to upload the existing cells into the program. When we open the "Cell Browser" on one of the laptops it does not show the "Variables" folder in the pull down under C:1 - Robot Controller. It shows the "Files and Programs" folder only. Anyone have an idea what would cause this or better how to correct it? Attached are pic's of each of the laptop screen's. Thanks in advance for any help.