RJ-2 controller is always stuck in hold. Haven't found anything in the manual. The company I work for had purchased the robot a coulple years ago, set it up and it has never operated. I have only beem emoyed by them for a few months and today decided to get working on it. After correcting some other issues this is where I am. I know on the rj-3's which our other 5 are I can change the UI, but on the 2 you dont have the config option. Still not positive that it's not a wiring or other issue but I would like to know of there is some where in variables that I should be looking for. Thinking we might be better off finding an rj-3. Thanks.
RJ-2 Stuck in hold
-
Brandon Garner -
February 16, 2019 at 1:00 AM -
Thread is marked as Resolved.
-
-
Maybe start looking at this thread....
-
[quote='fastfingers','https://www.robot-forum.com/forum/index.ph…9023#post129023']
Maybe start looking at this thread....I have and few others that are on here. Just trying to find of it is possible the chsnge UI in variables like you can in the rj-3 in config.
-
[quote='fastfingers','https://www.robot-forum.com/forum/index.ph…9023#post129023']
Maybe start looking at this thread....I have and few others that are on here. Just trying to find of it is possible the chsnge UI in variables like you can in the rj-3 in config.
I would be more interested in where the hold is coming from.
Sent from my SAMSUNG-SM-G891A using Tapatalk