Hi,
have a question about Wiring harness replacement for both a M-10iA, and a M-710iC/70 kg !
Is it possible to change the main wiring harness on both of these robots, without a total disassembly of the robot ? We recently had to repair one on
our M-10iA because it had a wire Red wire exposed showing copper, up by the J3 axis.
Our 710ic is close to the recommended Harness change for Hours.
I've been to Fanuc Training for both of these Robots, those classes were for total disassembly and reassembly.
Is it possible on both of these to change the harness's without taking them apart ? We were not shown that
Is it possible to fish it in and out without disassembling the Robots ?
Thanks Paul.....