Hi to everyone.
I'm a Robot Fanuc Programmer.
I'm trying to communicate with an S7 314-c using PROFINET.
From the robot side I can see in the Profinet IO Application that the communication is valid and Run (green dot)
R30ib is the controller (Port1).
S7314-c is the devcice.
I suppose that the IO config is done properly (8 byte In and Out - Rack101 - slot1- start1).
But If I set ON my configurated output, on the PLC side the DI didn't go ON and Viceversa.
How can I solve this?
Thanks to everyone
Best Regards
Aldo